Filamentspool holder
Tamsin Ferrer
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2021-03-16 21:26:36
0
0
000설명
모델 소스
리뷰(0)
Summary
I've desinged this for my Filamentspools because I was tired of the axle holders ... .
It is possible to use it from small spools (800g maybe less) to big ones (about 5 kg).
You have to print the spacer four times.
You will also need:
-
4 x 608Z bearrings
-
4 x M8 nuts
-
4 x M8 washers
-
screw locking varnish (or safetynuts)
-
2 x M8 threaded rod about 15,5 cm
- 4x stickable rubber feet (to prevent it from sliding)
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.1 to 0.2 mm
Infill:
20
Notes:
It should be possible to print everything without support.
모델 소스
원본 링크: 자세히 보기
CC BY