I'm a chunky guy and most holster's like to press a firearm into my side. This Goes to a Canik METE SFT holster. Made with 3d Fuel pla+ black, I print them on the side no support and at 50 mm/s on the ender 3 pro. for durability sake 15-50 for infill. feel free to make adjustment's as I made it 10mm spaced for me. in black filament the screw nut are tight in brown pla+ there were fine.

(edit "updated") so I got a comment saying the hook ran into your finger when holstering preventing you're grip from being proper. I have went ahead and moved the clip 5mm out and down to help improve grip. as of wed feb 22 9:12 am Im starting to print these so there untested, I have also rounded the top edge so it doesn't poke when sitting.

(day after mentioned) printed works fine just make sure bed is leveled you may need a brim due to decreased surface area due to mine pealing up on the tip. feels a lot better not digging into my side anymore and I cant even tell its there only by the weight. I've included the fusion 3d file if you want to mess with length I just chop the loop off and move it then reconnect them and redo the neck. I wouldn't recommend decreasing width to pull it closer to you as your finger would then hit the belt loop.

Creality

Ender 3 Pro

Doesn't Matter

No

0.2

15-50%

Designed fusion 360 in mm