This is a basic stand for the X-UAV Mini Talon. It keeps the nose of the plane slightly down compared to the rear as I wasn't shooting for something 100% balanced (if there is enough demand I may make a new front that is slightly taller to balance it). There is enough clearance for the rear fin with mark_q's rear skid plate ( # 52105 ).

i3 Prusa Clone

Doesn't Matter

No

.1

15%

Above settings are just what I used. Really doesn't matter much as long as you print it on it's side.

Because it's rather large you need to print them separably and at an angle on a 200mmx200mm printer.