I could not find the exact Xbox 360 controller analog thumb stick I wanted, so I created one myself. These are a little bit higher (2mm) than the standard thumbsticks as I preffer them that way.

V2 of both files have a slightly thicker thumb pad.
V3 of both files have a slightly thicker base shield wall to hopfully make slicing a bit easier.

Please share your makes!

Anycubic

All-metal Mega

No

Yes

0.1mm

100%

Only needs support from bed. Use 40% density, add 1mm extra inflation distance and add 3 support base layers for better printbed adhesion. Set the pillar resolution to 2mm and max overhang angle to 70%. After applying automatic support (Simplify3D) ensure to remove the most middle supports manually that go into the middle peg hole.

Remove support material and when fit is to tight, use a small file / grinding tool to remove a little bit of material from the inside.

I designed this using Fusion 360