This is a simple stand for a Saitek/Logitech flight panel to stand on a desk.
You will need 2 x 8mm M4 bolts per leg.

Best to print 2 feet per panel.
It's certainly possible to use with 2 flight panels on top of each other, but I haven't tried.

Note: I used it to stabilize and stiffen a larger installation on a desk (see photo). When you install the saitek modules from the yoke, you end up with a 1.3mm gap between the lowest module and the desktop. The throttle mount doesn't quite fill that gap and it's rather unstable. The problem is solved by printing this simple foot.

I also put the STEP file to adapt this foot to your needs.

Creality

Ender 2

Doesn't Matter

Doesn't Matter

0.2

25%