Designed by Drafting 12 student, Tyler A.

He needed another clamp for his drum kit to attach the cowbell.

His design works great in terms of fit and mechanics. However he is scared to hit it too hard in case he breaks the plastic rod. Ideally this would be created out of aluminum. It was a great exercise in design and prototyping though.

We printed ours using Red PLA.
Support: required for clamp 2
Bridging: needed for rotator piece
Nozzle Temp: 185
Bed Temp: 0
Infill: Rod 100%, other parts 50%
Shells: Rod 1, other parts 2

Other parts used:
3 wing nuts
One 7mm diameter eyebolt
2 7mm diameter bolts