Summary I've been tired of the stock front panel for a while. But, I also don't want to have the controls fixed to the front of the machine. What if I want to move the display in front of my webcam? What if I don't want to get up to start a print, or change settings? For these problems, and more, I developed a nice little enclosure for the LCD, buttons, and SD card reader on our printers. Prints wonderfully, sometimes both do without supports! Back is definitely support/raft free. Front should be raft free, support is YMMV but my machine does the SD card slot bridge with no support/no issue. Still working on a proper snap connection. Print Settings Rafts: NoSupports: Doesn't Matter Post-Printing Screw some M3 bolts into the bosses provided, holding the stock components in. You have a lot of wiggle room with screw length. I'm using spacers to keep the bolt heads off the board, but do whatever suits your fancy.