SummaryOpenForge ========= These strips are designed to let tiles with walls along their edge (instead of on top of a square) to be able to but up against each other. You only need these buffers if you are using the OpenForge edge series. There are three basic sets here: Lines The lines are the same length as the squares (1x-4x) of the squares on the tiles. corners The corners are the same length as the squares (1x-4x) of teh squares on the tiles plus a hub that's wth width of a wall from a wall tile. They can have 1-4 spokes coming off that hub. For most people anything past 3x length with 3 or more spokes is unprintably large. corner walls Corner walls are the same as corners, except they also have a wall height spoke going up. These are designed to fill in gaps between walls butted up against each other. In most cases, only 1 or 2 spokes are actually useful, but all are uploaded for completeness. You can find this set on github OpenForge Sets ============= Smooth Tile Series - Smooth tiles that can be used as concrete, dirt, ice, etc. Smooth Edge Tile Series - Smooth tiles that can be used as concrete, dirt, ice, etc. Edge tiles. Stone Tile Series - Stone tiles. Stone Edge Tile Series - Stone edge tiles. Crenelated Tile Series - Crenelated Tiles Crenelated Edge Tile Series - Crenelated edge tiles Tudor Tile Series - Tudor tiles. Tudor Edge Tile Series - Tudor edge tiles. Ruined Series - Ruined stone walls Accessories - Pillars, etc. Non-Series Tiles - Misc tiles, such as the pool Module Specific Tiles - Tiles designed for specific modules. InstructionsPainting Painting was done in 4 layers. Paint whole piece in black Heavily dry brush with a dark grey dry brush with grey mixed with a little olive lightly dry brush with a light grey, focusing most heavily on edges