Summary

Bumper case for Pixel 3. Needed something quick before an upcoming trip.

Original idea was to scale zvalentine22's Pixel 2 Bumper:
https://www.thingiverse.com/thing:2614340
But found that the buttons were off. So modified the button cut-out and made the case symmetrical top and bottom to protect the glass.

Model versions:
V7 - 68.5mm wide
V8 - 69mm wide (for rigid filaments)

Scale in slicing software to fit phone for printer calibration.

TIP - Install phone from back of bumper (modified top and bottom bezel to be a little thinner). Easiest if corner above button cut-out is the last to be inserted.