Summary

This is the official edition of the Donkey Car. For more information go to www.donkeycar.com. By default it supports the Raspberry Pi, but there is also an adapter for use with the NVIDIA Jetson Nano. Special thanks to Doug LaRue and Jean Marie whose adapters my design was based on.

It supports the following cars:

• WL Toys 1/14 scale buggy
• Magnet
• Desert Monster
• SCT
• Blaze
• LaTrax Prerunner

This is the new version of the donkey. it prints faster and assembles faster than the old version, the downside is that it uses specialty hardware that can be hard to find. It uses "Thread Forming Screws" also sometimes called PT screws. the sizes we use are:

(3) 3mm diameter 10-12mm length for chassis
(8) 2.2mm diameter and 6-8mm for Raspberry Pi and servo driver.

These screws are available at specialty retailers or can be purchased in the Donkey store for $5 shipped. https://store.donkeycar.com/collections/accessories/products/plastic-thread-forming-screw-kit

Current F360 file is here https://a360.co/2STUhf5