The simple kitchen capture rack of the Essex Solid Waste Management Authority in southwestern Ontario

I believe this also applies to Resin.

Print it as a 3MF file like this

25% gyroscope filling material

Four walls, as shown in the figure, providing vertical support

15 mm/s for the first layer

The printing time for a single item is about 2 hours

It can print horizontally, but due to the lack of support and other reasons, the internal texture is poor

You can do whatever you want with it, print it, sell it, or modify it. I'm not fussy about it

Please note that I'm sure this model is suitable for any filament I just printed with PLA. Your usage methods and results may vary