The Key - Puzzle Box
BalmyTrail
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
1
1
0
게시일:2026-04-29 04:47:23
2
0
110설명
태그
모델 소스
리뷰(0)
Commercial here:
Assembly and SOLVE NEW! (Jan 8, 202)
The Key - Puzzle Box is an original design by Leisure Luke. It's a 7 Piece + 2 BONUS Pieces set that is EASY TO PRINT! No Supports, PLA ONLY,
No External springs, no bearings, no electronics, NO GLUE!
100% PLA 3D Printed!
Print all 9 pieces and they'll fit together pretty easily. The T6 is the only difficult piece to get onto the pv3. The spade cap goes on the H1 after it's threaded through the H2.
Again, see the youtube video for assembly - which starts at the 5:00 mark.
Leave your comments, and tune in for the next version - which will reuse the Pv3 platform, T6, and possibly more!
These are all modular pieces that will be a part of a larger project... that I rambled on about in Episode 1 :P
Enjoy!
Print instructions
Unassociated tags: 2020 Puzzle Box, 2021 Puzzle Box, funny thing, gift box, impossible puzzle box, Leisure Luke, level 10 puzzle , level 11 puzzle, level 3 puzzle , level 4 puzzle, level 5 puzzle , level 8 puzzle , level 9 puzzle , luke bohnen, mr puzzle, multi step puzzle box , mystery box, New Puzzle Box, Puzzle Box, youtube puzzle box
Category: Puzzles Summary
Commercial here:
Assembly and SOLVE NEW! (Jan 8, 202)
The Key - Puzzle Box is an original design by Leisure Luke. It's a 7 Piece + 2 BONUS Pieces set that is EASY TO PRINT! No Supports, PLA ONLY,
No External springs, no bearings, no electronics, NO GLUE!
100% PLA 3D Printed!
Print all 9 pieces and they'll fit together pretty easily. The T6 is the only difficult piece to get onto the pv3. The spade cap goes on the H1 after it's threaded through the H2.
Again, see the youtube video for assembly - which starts at the 5:00 mark.
Leave your comments, and tune in for the next version - which will reuse the Pv3 platform, T6, and possibly more!
These are all modular pieces that will be a part of a larger project... that I rambled on about in Episode 1 :P
Enjoy!
Print Settings
Printer:
Artillery Sidewinder X1 V4
Rafts:
No
</div>Supports:No
Resolution:
0.2
</div>Infill:15%
Filament: TECBears PLA Black, Red Silk, Marble, White, Gold
Notes:
Print the t6 part first. If that doesn't slide nicely, you may have to adjust your extrude speed to something lower. Your printer has to be fairly dialed in for all the mechanisms to work properly. See the video for more details.
태그
모델 소스
원본 링크: 자세히 보기
CC-BY