Blooming Flower
Wide Ingot
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
7
6
0
게시일:2026-04-04 13:24:09
4
0
760설명
태그
모델 소스
리뷰(0)
Print in place flower that blooms. Model size is approximately 75mm diameter x 50mm tall, opens up to 130mm diameter. Pictured model printed at 0.15mm layer height with 0.4mm nozzle on Creality K1 in PLA plus with standard settings. After printing, cut the small bridges between each petal around 10mm (can see the exact location in the slicer preview). Before printing, make sure bed is clean and adhesion is really good as the petals are somewhat weak until the bridge splices are printed. Printing at 0.20mm layer height may cause parts to fuse.
태그
모델 소스
원본 링크: 자세히 보기
CC BY