分享模型，侵权联系删除，DO NOT CHANGE THE Z-HEIGHT. For ease of use, i suggest unchecking the “UNIFORM SCALE” and change X and Y Percentace only when editing size;

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

You may print at higher layer heights below the Min Depth of 0.48mm

The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:

PLA BambuLab Matte Charcoal Transmission Distance: 0.6

PLA BambuLab Matte Scarlet Red Transmission Distance: 2

PLA BambuLab Matte Lemon Yellow Transmission Distance: 4

PLA BambuLab Matte Ivory White Transmission Distance: 3.5

This print uses 4 unique filaments

Swap Instructions:

Start with Charcoal

At layer #17 (1.44mm) swap to Scarlet Red

At layer #21 (1.76mm) swap to Lemon Yellow

At layer #23 (1.92mm) swap to Ivory White for the rest.