A simple stand for the OG Novation Launchkey Mini music keyboard.

I don't know if it'll work with the updated MkII editions or not since I don't own one. Feel free to try!

I attached mine with removable double-sided tape. It's strong enough that it won't wobble or fall over in use. Nice and sturdy, you can get angry at the keyboard and this will support your deathly ambitions. I know it has supported mine 🔨(keyboard donations accepted😭)

If your desk is smooth, you may need some rubber feet for the bottom. You could get premade rubber feet, print some TPU pads, or throw some double-sided tape on the bottom for a quick fix.

As a super easy/cheap temp hack (travel, no time), if your desk has a smooth laminate top (like a kitchen counter), wet and completely wring out two small pieces of paper towel, and put them under each leg. It should stop it from sliding around. May depend on the surface and print material. This also works for (and the idea comes from) cutting boards in the kitchen.

Print Settings

• Default settings for most any printer are fine

  • 0.2mm layer height

  • 0.4mm nozzle or larger

    • 0.6mm nozzle is great for faster prints on structural objects like this

• PLA is a great material for these stands, would look great in silk/sparkle/metallic too

Fusion File

• Fusion 360 file (not parametrized) provided if you want to try to fit it to another edition.

Attachment Tape Used

• XFasten Double Sided Tape | 1/4 Inch x 20 Yards | White | 8-Pack

• You can buy it from them directly or the usual suspects