I designed this microgreen grower to make growing microgreens much faster and more efficient, i have added a drainage system to drain of the access water, I also included a slot to add a light strip so that sufficient light is provided for the plant and added a slot for the cable to pass through.

print with support
when using make sure to cover base with a plastic sheet and add holes to it, also remove water from tray frequently to stop filament from expanding if using PLA.

Instructions:
when using make sure that tray is kept right below the pot so that it collects the water which prevents it from spills and expansion of filament, place the top part(light strip holder) on top of the pot and cut 2 of 17 cm light strips and place them in the socket. then soldier them to a wire and connect it to a power source(make sure that the wires are passing through the sides(the cut for the wires).