Darth Vader HueFuge

Project: vader.hfp
Use a layer height of 0.08mm, a base layer height of 0.16mm, and print with 100% infill

The model size is 150.65x200mm.
You can print with a higher layer height, but it cannot be lower than the minimum depth of 0.48mm.
The maximum depth is 2.2mm, and the actual depth is 2.2mm.

Consumables used:
PLA BambuLab Basic Black. Transmission distance: 0.6
PLA BambuLab Basic Blue-Grey. Transmission distance: 3
PLA BambuLab Basic Grey. Transmission distance: 2
PLA BambuLab Basic Ivory White. Transmission distance: 5
This print used four different consumables

Switching instructions:
Starting with black
Switch to blue-gray on the 8th layer
Switch to gray on the 15th layer
Switch to jade white on the 16th layer