I found this fishing rod holder model, but I'm not quite sure how to install it. Either there's no installation mechanism, or it requires screws at every position, which is ridiculous. I added a base plate with two screw holes, and the hooks are mounted on it, which means only two holes need to be drilled. As long as the screws are installed on the wall plugs or using drywall anchors, any screws can be used, but it would be better if you have larger screws.

It fixes the fishing rod through the raised part before the guide ring, which means the guide ring is suspended and will not touch the shelf. Therefore, it will not be subject to any force, and you can safely store the fishing rod in this way for a long time without damaging it.

It's not modular, but you can print up to 9 pieces at a time on the A1 mini, which means you can get mounting brackets for up to 36 fishing rods in a single print. You should use PETG for printing, although I don't think this is a problem. However, if you're worried about scratching the fishing rod blanks, just place some felt or vinyl at the contact points. It's very sturdy when printing vertically, but if you're really concerned about this issue or if you're hanging very heavy fishing ro