Abstract

In order to improve the performance of the radiator, I placed a fan above it. To make it look nice, I wanted a simple way to create a tight connection between multiple fans. The screwless fan connector was born.

I've already tested the Arctic fan, but it might also work with many other fans.

For my usage, clamping on one side is enough, but for extra stability, you can clamp it on both sides.

To remove the clip, you need a wedge or long nails to take it out

Print settings

Printing machine:

Bambu Lab P1S

Raft layer:                     

Yes

Support:

No

Resolution:                     

0.28

Fill rate:

15%

Note:                    

To achieve maximum strength: print with the flat side of the pin facing down! Otherwise, the pin will break.
 

Maximum overhang = 30%

You can try not to use a raft layer/edge, but since the parts are very small, I have a 50% success rate, so it's better to add a raft layer/edge.