This is an attachment for 32mm conduit for a dive gate using extendable tent poles for our local FPV drone club.

The tent poles are steel, galvanized, and have an 8mm spigot on top. We simply remove the feet and slip them over some small rebar. This setup makes it easy to install, lightweight, and simple to put down when a drone gets stuck in the gate. 🚁

Note: You'll need to print off two sets for this setup.

Creality

Ender 3

Yes

0.2

40%

I printed with 4 walls and it has seemed to hold up in the wind pretty well.