Putting some puck leds into the canopy of my UTE and made this so i can secure the remote but still be able to slide out if needed, Preped the area with some iso alcohol and used 3m double sided tape to mount. Didn't check if there was already a model available but fairly confident with fusion now so by the time i had found a model and made the changes to suit i would have already made up a model that would be exactly what i needed. 

Dimensions of the remote 7mm thick, 40mm wide and 80mm tall- and i made the walls 3mm thick all round. print standing up- I used PETG but PLA should work fine with 15% infill. 

if i could remake this i wouldn't make it as tall so i can get a grip on the remote to pull it out but there is a enough of a lip on the remote to remove it easily