I wanted to mount my USB switch so that it was centered above the monitor on my multiboard wall.

Given this location, I wanted it to be slightly angled for the purposes of visibility and functionality.

So I angled the base, and then added an opening that is compatible with a multiboard bolt.

I printed it in 30% PLA with organic supports.

Make the bolt snug with a multiboard bolt wrench, as it can move side-to-side over time given the location of the button to the left of the bolt – this is not a big deal at all.I wanted to mount my USB switch so that it was centered above the monitor on my multiboard wall.

Given this location, I wanted it to be slightly angled for the purposes of visibility and functionality.

So I angled the base, and then added an opening that is compatible with a multiboard bolt.

I printed it in 30% PLA with organic supports.

Make the bolt snug with a multiboard bolt wrench, as it can move side-to-side over time given the location of the button to the left of the bolt – this is not a big deal at all.