101Hero Controller Mount
sphere.fix
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2025-12-27 05:06:20
0
0
000설명
모델 소스
리뷰(0)
I took the top mount and made some adjustments for a sturdier fit.
Inside the notched end is 20mm to prevent the bracket from sliding
Two corners of the inner fill are curved so the bracket rotates in and locks.
Print two of these to securely mount the controller box to any of the towers.
Note: The bracket will only turn clockwise. For the bottom bracket, the fingers of the bracket should be facing 9 o'clock. For the top bracket, the fingers should be facing 3 o'clock.
Version 2 has thicker sides to help prevent breaking if control box is bumped hard.
Print Settings
Printer:
101Hero
Rafts:
No
Supports:
No
Resolution:
0.18mm
Infill:
20%
Post-Printing
Installation
Hold bracket sideways and insert into the opening of the tower fitting the legs of the bracket around the tower wall.
Insert the bottom bracket in the lower tower slot, slide down and rest the controller box in the bracket with the power switch facing up. Insert the top bracket in the upper tower slot, rotate it and slide it down to rest on top of the controller.Note: The bracket will only turn clockwise. For the bottom bracket, the fingers of the bracket should be facing 9 o'clock. For the top bracket, the fingers should be facing 3 o'clock.
모델 소스
원본 링크: 자세히 보기
CC-BY