Wanhao i3 hex key holder
Boris Feldman
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2026-03-30 07:37:06
0
0
000설명
모델 소스
리뷰(0)
This is a hex key holder for the Wanhao Duplicator i3 v2.1.
I needed a place to hold my hex keys, and I noticed a couple of small holes on the side of the gantry (probably for putting a z-switch on), so I designed this little part to go there. It fits quite snugly and holds the keys very well.
The v2.1 comes with these holes, other versions might not. Check before printing.
Print Settings
Printer:
Wanhao i3 Duplicator
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.3
Infill:
15%
How I Designed This
I used OnShape to design this (as I run Linux and none of the "professional" tools will run). Feel free to remix it:
Category: 3D Printer Accessories모델 소스
원본 링크: 자세히 보기
CC-BY-SA