In the past I glued the strips with silicone on stone, then screwed the strips every 20cm, and I had to remove screws, change strips and then put screws,
Now what I have created is a clamp support to insert the 5050 RGB LED strip ip65, and with this I avoid having to remove screws to be able to change the LED strip.

And finally I have created the same clamp with the possibility of placing the LEDs at 45 degrees, and in two clamp positions according to mounting convenience. (At 45 degrees I like the use of the light generated by the LED better.

Creality

Ender-3 v2

Yes

0,32

40%