Enclosure to hold control electronics for a 500W brushless spindle, including the on/off switch, speed control potentiometer and speed display.

The bottom of the enclosure is empty as it is to be mounted to a wooden base.
The power wires then enter from underneath.

I have not included any vents for airflow. I want to keep dust off the electronics if possible. The controller stays cool in operation when run open on the bench. I will keep an eye on the internal temperature and add a fan in the future if required.

VoronDesign

Voron2 250

No

No

0.2

38%

Additional hardware:
4 off M3x 6mm heat set inserts.
4 off M3x10 button head bolts to hold down lid.
Gx16 3 pin connector used to bring out wires to the spindle.

M6 bolts used to secure control box to the table top.

The lid contains text that can be printed in a separate colour.
Details on how to do this can be found on https://docs.vorondesign.com/community/howto/mikhail/multi-colour-prints-with-a-single-nozzle.html?fbclid=IwAR0U7-qqKsJKF_E84XquxRQwKGt4Kae6okkFQuN4cR8QiXkYAlYfZuJWvRw

LCD display and switch clip into front panel, but I added a few small blobs of hot melt glue to secure.