MP Select Mini Pi Case
Amy3d
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2026-02-27 06:48:00
0
0
000설명
태그
모델 소스
리뷰(0)
Hang your Octoprint-running Raspberry Pi off the back of your MP Select Mini with this case. The Pi is friction-fit. About half of the GPIO pins are uncovered for use with e.g. my filament sensor.
Post-Printing
Adding the Pi
Slide the cap part onto the ports of the Raspberry Pi from the bottom. Then slide the Pi into the case with the cap sticking out.
Mounting the Case
Unscrew the two backmost screws on the "tower" part of the printer. Line up the screw holes on the case with those of the printer and screw the screws back in. (If the screws had washers on them, don't use them; the plastic of the case serves the same purpose.)
태그
모델 소스
원본 링크: 자세히 보기
CC-BY-SA