I know there are many other Dremel tool organizers, but none of them really met my needs.

Creality

Ender-3 V3 SE

Doesn't Matter

Yes

regular 0.04 nozzle

20%

For orientation, You can either put the base on its side, or sit it flat, upright. I used normal supports touching the build plate. (Tree support would have been better) I just had to do a bit more clean up with normal supports. The compartment drawer just needs support for the handle.

I added 2 drawers. The first drawer is the compartment drawer. It has spots for cut off wheels, polishing pads, and small sanding discs. The other compartment drawer I left empty in case you would rather just keep everything loose.

I used regular PLA and the base took around 9 hours to print. However, I did print the drawer with the base at the same time.

I know there is a lot of Dremel organizers on Thingiverse. However, none of them had what I was looking for in an organizer. Other organizers are so big, it took up much valuable space on my pegboard and sticks out way to far. The other problem I was having, every time I would accidently bump the tray organizer, parts would fall off. So I had 2 things in mind when I designed this holder. 1. Make it small enough, but have places for everything. 2. Design it so parts don't fall off every time it gets bumped. This design, I tried to make it small enough that it fits in the limited space of my pegboard. Then I designed places for the 3 different cut off wheels with the quick connects. Top of the base, there are holes to drop in grinding tools and wire brush tools. The compartment try is for all the smaller polishing, sanding, and regular cutting discs and has places designed for them. I also added an empty compartment, just for those of you who would rather keep your parts mixed all together.

This Dremel Tool Organizer is much smaller. Measurements are 141.6 mm x 89.5 mm with a height of 64.7 mm. It fits on my pegboard nicely.