Remix!

Does NOT fit Ender 3 Pro with the slim PSU, this is for the standard Ender PSU that is 50mm wide.

I liked the design from Zoly, BUT I wanted to make some changes. For the "rear_left" I added some loops inside for zipties and filled 2 holes (since my ender does NOT have the 40x40 holes tapped). On rear_right, I filled the same 2 holes. For the front feet, I just cut off the "tab" he had to screw them into the aluminum, they slide in and hold just fine as is. The "v-slot" is untouched.

Will upload pictures shortly, marked as WIP.

Creality

Ender 3

No

Yes

0.2

25%

Only need supports for rear_left where the small overhang is.