A simple and strong controller holder that fits all normal two handed controllers (so not wii-mote or N64). Also looks nice enough I got permission to hang them in the living room!

Needed a place to mount my steam deck on the wall, two of these next to each other worked perfectly.

Print two arms in the orientation provided in the file, and the back. Superglue the arms into the backplate in their slot. The slot has sides that prevent the glue from being visible and a little pocket up top that the point end of the arm slots into to provide extra support.

When installing arms, the pointy end up into the pocket just until the bottom is able to slot into the base.

Creality

Ender 3

No

No

.2

doesn't matter

Don't use supports, even it complains about the overhang on the "pocket".

Did not need a brim/raft to stay flat for me but my current setup has great adhesion.

It's important to print the arms on their side, it makes it so the weight of the controller isn't trying to peel the layers apart (like would happen if the whole thing were printed as one piece) massively improving the strength of the hook.