Weezer, Flying W Logo Marquee!

This creates a replica of the Flying W Marquee they use on tours, non-stretched version.

The additional items I used after 3d printing is listed below. This is sized for these specific items.

Included in files is a split version that would need to be glued if you have smaller printer and a full size if you have a larger printer.

Fairy Lights (I bought these because you can just cut off the non-needed lights on the end since the way it's wired with 2 wires straight), Link: https://a.co/d/2PcY6sv

Bulbs (I bought these and pulled the lights out of the globes with pliers. you'll have way more than you need, but some are tougher to get out so you may break some on attempts), Link: https://a.co/d/fBXvzr3

See picture included for wiring.

Anycubic

Kobra 2

No

Yes

.15/.2

10-15%

Back of print will need to be cleaned up, but it's the back and not visible