Triple tablet stand (against wall)
gruffbeaver21
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2026-03-04 14:09:08
0
0
000설명
모델 소스
리뷰(0)
This is a triple tablet holder that was specifically made for table that's against a wall. There is a space under the far edge that you can pass cable (and window sill) through.
I've stuck two painter's tape to make it double-sided to hold it in place (it'll fall otherwise).
The model isvery specific to my desktop environment. I may post a parametric version in OpenSCAD after I try out some prototypes.
Print Settings
Printer:
Prusa Mini
Rafts:
No
Supports:
No
Infill:
10% gyroid
Filament: HatchBox PLA Gray
Notes:
Print on side. Try a skinny version to test if it fits your tablet.
모델 소스
원본 링크: 자세히 보기
CC-BY