I found the little alignment nibs broke off too easily. I lik e bigger pipe which I run off a little turbine like compressor with a 10 id. so I just made added an adapter. The air assist is a quick easy print but the air doesn't blow on the laserpoint strongly enough, kind of blows in the general direction. It still a neat little design.

Creality

Ender 3

No

Yes

0.2mm

24

I ran it a little slower than usual to make sure the SBS sealed between layers. Did one (original) on the creality ender 3 and the new one on the 6, but used PLA... harder.....

I used a Alibre.. it is so simple to import and remix. no complications. People! really try this much easier... oh! Alibre you could make a little free one for people to use.