Handy little Pencil Pistol. Turn any pencil into a classic revolver! The Model includes a holster with a pocket clip so you will always have the perfect place to keep your pencil.

The chamber unit is separate from the handle section and they will need to be glued together.

The "full" model contains all the parts in one file (v1).

Holster v2 has a slightly thicker integrated clip.

Holster v3 has a separate clip that needs to be glued to the holster section. The benefit is that the clip can now be printed on its side, and the holster can be printed vertically. The separate clip is attachable to any corner of the hexagon, allowing for the clip to be attached at various positions. (check to make sure its right way round before gluing)

Printing: I recommend printing the v1/v2 holster on its side with supports for clip strength. Print the v3 clip on edge to give it the most flex and strength. The v3 holster should be printed vertically for the best result. Printing the handle upright with supports yields an good result. The chamber section doesn't need supports if printed on end.

Creality

Ender 3

No

Yes

200

18 - zigzag

Pew! Pew! Pew!

Where I work it's good to have a pencil on hand, but I don't always have a good spot to keep one. So I thought a holster would make carrying one around much easier; And it works! (Besides who hasn't held a pencil and gone "pew! pew!" before?)