*Note: I will be up to make some minor changes for people but please don't request mounts for other sensors that are not compatible with the TronXY XY-08N or the Anet Z Probe.

I had rigged my sensor to the side of the original extruder mount but wanted a better solution. I put this together in 3 varieties. One to have the sensor on the left, one to have the sensor on the right and another to have it on the left with the mount bracket only 2mm thick instead of 3mm to allow wiring to come out the front on that side. I have mine setup so the wires for the X endstop just come out of the front hole on the left side instead of running through the extruder mount to the right side.

To make your life easier, I highly recommend using the nut holder. If the nut is loose in the holder use super glue to hold it in place. If it is tight, heat it up and press it in.

Print Settings

Printer:

Hypercube Evolution

Rafts:

Supports:

Doesn't Matter

Resolution:

Infill:

50

Notes: