Included are three separate file options, mirroring the same designs from the original. There is a 2-slot, 4-slot, and 6-slot variation to fit most needs. Pictured is the 4-slot option with build plates for an FLSUN V400.

Printing suggestions:

PLA works well, but PETG is a better choice for a busy 3D printer space. PLA will require 20% to 30% infill, or add more walls as an alternative. The thin dividers between the build plate slots is where strength is needed. If using PETG, 15% to 20% infill have proven to be adequate.

These models are large. The only option that fits on a Prusa i3-sized printer is the 2-slot, rotated to a 45 degree angle. A 300mm diameter round, or 280mm square build surface are the minimum sizes that will print any choice of the three models. Make sure you have at least 200g of filament available in your preferred flavor.

This holder will accommodate up to 320mm round build plates. This is suitable for delta printers up to and including the the FLSUN S1.