I wanted to use the E3D extruder but the sensors used in the remixes only had 4mm detection. The standard Anet sensor has 8mm so I had to redesign the mount.

Also added mount for top of fan.

Update:

Added extra fan and chain arms - cleaned up sensor guides.

For Skynet im using these settings which give me a perfect bed centre:

#define X_PROBE_OFFSET_FROM_EXTRUDER 30 // X offset: -left +right [of the nozzle] #define Y_PROBE_OFFSET_FROM_EXTRUDER 5 // Y offset: -front +behind [the nozzle] #define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]

#define X_MAX_POS 220 #define X_MIN_POS -18 #define Y_MAX_POS 220 #define Y_MIN_POS -22 #define Z_MAX_POS 200 #define Z_MIN_POS 0

#define LEFT_PROBE_BED_POSITION 20 #define RIGHT_PROBE_BED_POSITION 195 #define FRONT_PROBE_BED_POSITION 20 #define BACK_PROBE_BED_POSITION 170 Print Settings ==============

Printer:

A8

Rafts:

Supports:

Yes

Resolution:

Infill:

75%

Notes:

Category: 3D Printer Extruders