This is V" of a previous design with room to remove the sd card

given the location of my ender 3 V2 and how i use it the usb cable and micro usb port were practically susceptible to damage either from accidental knocking or repeated use so i designed this to project the usb port you will also need some small and and fairly cheap parts links below this only took me around 17minutes to print and 3g of pla so its well worth trying

print one copy of the part
insert the USB micro to USB C adaptor into the hole (its an extremely tight fit and the hole mad need some slight tuning to get a good fit
apply double sided tape to the lower part and stick to printer inserting usb port at the same time

as always feedback and comments are always welcome and appreciated and OBJ files are available upon reasonable request

https://tinyurl.com/r2n7e6fk (usb adaptor)
https://tinyurl.com/3rcxk49u (usb cable)
https://tinyurl.com/yp75ymfh (double sided tape)

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.2 / .3

Infill:

Filament:
PolyMaker PLA

Category: 3D Printer Accessories