Salt shaker refill funnel
Pebble Buck
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
1
1
0
게시일:2026-02-13 23:52:14
1
0
110설명
모델 소스
리뷰(0)
Small funnel designed specifically to refill 250g salt shakers with the rotating cap as shown in the picture. Prints fast, requires very little filament and helps save a few pennies by refilling the salt shaker quickly and easily.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Filament:
Generic PETGTransparent
Notes:
Preferrably to be printed with a food safe filament: I used transparent PETG.
Designed to be printed in vase mode (Cura: "Spiralize outer contour") with 0 bottom layers and the rectangular base touching the buildplate. The sliced result should be as shown.Using a brim is absolutely recommended. The brim can be left in place after printing as it becomes a place to hold the funnel when pouring in new salt. Prints in less than 30 minutes with a 0.4mm nozzle and 0.2mm layer height, and hardly uses any material. At these print settings it is quite delicate, so maybe I suggest using a 0.6mm nozzle and 0.3mm layer height.
The model is weirdly oriented because I started from a 2D scan of the salt shaker cap to start designing the funnel, so that dimensions would be accurate.
모델 소스
원본 링크: 자세히 보기
CC-BY