After realizing that my modifications to my Ender 3 Pro PSU had made it not work with most of the existing Lack PSU mounts, I decided to create my own from the simplest design I could find. This seemed to be the ticket, so I hope some other folks might find it useful as well.

I did have to bust open a whole in the lower half of the PSU frame I printed in order to route the cables since the PSU is flush to the bottom of the Lack table, but then it was easy enough to make work.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Notes:

Only need supports on the plug end bracket, others can be printed without if they are laid down on the print bed.

Category: 3D Printer Accessories