A board for onebitpixel's Cathedral pieces. I didn't have anything else where to glue those corner pieces, so I printed this board.

I scaled the pieces to 60% of the original, printed those and made this board for them. The 4 corner pieces should be glued to this to form the playing area.

If you printed the pieces in the original size, you need to scale this up.

Instructions

Make sure you print in the right size.

I printed the flat side down with a 80% infill from white ABS. Didn't have any problems with warping as I was using a heated PEI bed with some PVAc glue on it.

Category: Games