This battery storage is 5.760 inches in length by 4.375 inches in width by 1.750 inches in height. At each corner there is a small rectangle that is about 0.750 inches in length by 1 inch in width by 0.125 inches in height. You can drill a screw through these rectangles to hang it on a wall. Just make sure you have screws that can fit in this small area. The battery storage can hold 10 AAA batteries, 8 AA batteries, and 4 9v batteries.

Bambulabs

Bambu P1S

Doesn't Matter

No

The infill I used was 7% 3d honeycomb for a strong print.

It doesn't matter what infill type you use, just make sure that the battery storage is strong enough to hang on a wall and can hold the max amount of batteries. I used 3d honeycomb infill because it is one of the strongest.

I designed this model using Tinkercad. I started by measuring the battery dimensions using a digital caliper. I then went back to Tinkercad and made holes in a large 3d rectangle. The holes I put in the 3d rectangle were about the same size of the batteries I measured.