An additional mount bracket for the Z motors on the Adimlab Gantry printer.

Hardware:
2 M3 x 12 screws for the motor
2 M4 x 8 screws to mount on the 2020 extrusion
2 M4 t-nuts

Install:
Put M3 screws in
Put on motor and start M3 screws
Push t-nuts into the extrusion and align with hole
Carefully install M4 screw and get started in t-nut
Tighten all screws, but be careful not to overtighten

Print Settings:

Infill:  35% Cubic

Filament brand:  Your Choice

Filament material:  PLA + or filament of your choice

Notes:

Print with the flat part on the bed (The part that after printing will be at the back of the printer).

Recommend 5 walls, 0.28 layer height, and 35% cubic infill at 60 mm/sec. Took 1 hour and 4 minutes to print.

Support is not needed, but can use for screw holes if desired.

Also, recommend printing the OEM bracket with these settings.