A stupid modular shower hanger thing I made, so that I can hang my Taotronics

shower speaker onto the shower glass.

Maybe someone else will find this useful, and will add more modules.

Each spacer segment is quite short - 14cm - as my printer is small (although this coincidentally makes the setup more portable). The hanger fits ~5.8mm thick surfaces.

Use blender or your favourite model editor to make your personal adjustments!

Print Settings

Printer Brand:

LulzBot

Printer:

Rafts:

Yes

Supports:

Resolution:

0.2mm

Infill:

Notes:

• Successfully printed using
  • PLA (210C, 70C hotbed)
  • 25% infill
• The hook and adapter can be printed in different orientations; you decide

what's best based on your printer and support preferences

• I used Cura to slice this, and for the spacer, I needed to disable both "Combine everything" settings in Expert settings, as well as enable "Keep open faces". I assume this is because I messed up the model somehow, but I can't see where. All preview modes look fine except for Layers, which seems to add infill to the top, even though that should be a hole.

Post-Printing

I've glued some of the parts together, which can be seen in the photos. This isn't strictly required of course, but the adapter plug I made for the taotronics probably needs to be glued onto either the speaker itself, or the spacer.

Category: Bathroom