Simple case for the "Atomic Pi" single board computer.

Because of the official model totally doesn't fit with the stupidly placed bottom power connector, i created this one.

You may add bevels and extra holes for electrical access to GPIOs etc. This version is simple and just for computing.

Power connector inside:
There's enough space left on the bottom for the power connector.
You may use bent Dupont jumper cables.
Wires have space on the side next to the sbc to reach the top area.
On my version i soldered wires directly on top.

Power connector outside:
5mm diameter hole for some power socket.

HDMI-Hole:
It has a bigger cut because some HDMI connectors may be bigger.

CMOS-Reset:
I already had to perform a cmos reset after no external EFI files could be found and booted. So you can reach it with a spiky tool.

SD card:
It's underneath to not accidently eject it. May be ejected with a tool or a longer nail.

Heat sink:
Until temperatures seem not to get too high, the heat sink is totally enclosed and safe.

Screws:
Only 4x M3x30 needed (20mm or 40mm length may work too)

Slice and print:
Has no holes to be infilled. So use 100% to support the scew areas.
Shell at least 1mm for stability. The model's shell is about 2mm and should be solid.
Use brim if needed. My corners have lifted a little without brim.
No support needed. No overhangs.
PLA did it for me.