This is a case for a 4x 7- segment and a single 7 segment (5 digit). It is used for DIY and prototyping. I used a header connector inside the case to solder wires from the segments. This exposes them externally from the case. I used a hot glue gun to glue the header in place. I also use the glue gun to glue the case together. It was to hard fort me to use jumpers directly on the 7 segment displays.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Filament: Prusa PLA Black

Category: DIY