This is the pod for the Escalibur 130+ stretched plus frame. A few last changes will come up soon, some have to try if there is enough room for lowering to top again.

It's derived from the earlier version 4.1, but designed from scratch again, has several improvements and shapes:
https://www.thingiverse.com/thing:2624446

++ removed hole for VTX display - thanks to Smart Audio/Tramp Tele
++ removed hole for VTX antenna - in you need, melt your own
++ added more space in front of the FC/ESC stack
++ added more space on top of the FC/ESC stack (VTX melted the canopy on hot days)
++ thicker walls to print in TPU
++ everyone needs a turtle fin - added a version

The earlier versions should be printed in PLA for best results. But this new Version is well printable in TPU for much better durability.

You can find the carbon frame at armattanproductions.com!
https://armattanproductions.com/pages/product_details/11567

You need three m2-screws to mount the pod to the frame.

This pod fits perfect for following components (Version 6 got some more space to fit different components):

Runcam Micro Sparrow V2 (or similar)
https://www.banggood.com/Runcam-Micro-Sparrow-2-Super-WDR-OSD-700TVL-CMOS-FOV-150-Degree-2_1mm-43-FPV-Mini-Camera-NTSC-PAL-p-1271733.html?rmmds=search&ID=44069

Eachine VTX03 Super Mini 5.8G FPV Transmitter
https://www.banggood.com/Eachine-VTX03-Super-Mini-5_8G-72CH-025mW50mw200mW-Switchable-FPV-Transmitter-p-1114206.html

XJB V2 PBF3 EVO Flight Control AIO
https://www.banggood.com/Upgrade-20x20mm-XJB-V2-PBF3-EVO-Flight-Control-AIO-PDB-BEC-D-shot-25A-Blheli_S-2-6S-4-in-1-ESC-p-1142584.html

FrSky R-XSR
https://www.banggood.com/FrSky-R-XSR-Ultra-SBUS-CPPM-D16-16CH-Mini-Redundancy-Receiver-1-5g-for-RC-Multirotor-FPV-Racing-Drone-p-1186057.html

Creality

Ender 3

Doesn't Matter

Yes

0.1-0.2

30% or more

Use 4 or more walls for better stability. Play with infill for better stability.

Support only needed for the openings at both sides, depending on you printer, its possible without, but with my settings it doesn't look very nice.

I'm still not happy with the front screws. Want to try different thread sizes, open for any suggestions!
Lower the top, quiet a bit high, doesn't look like my initial thoughts, have to check out if there would be enough space and air for my melting vtx.