Qrome designed a fantastic model, but I needed some parts specific to my hardware. This is his model design. https://www.printables.com/model/759660-slow-stick-fpv-plane-with-carbon-fiber-arrow-shaft

For this model I plan on using Radiomaster RP4TD ExpressLRS Rx and wanted to integrate a mount into a camera pan mount to save weight and room on the arrow shaft. I created a mount that holds antennas at 90 degrees to each other and has a cutout for a MG90D servo that will have a camera mounted to the servo shaft. In this example it is a bi-plane and is mounted up. If using on a single wing, mount it hanging below the arrow shafts. This mount was inspired by a mount designed by MSD Logic. https://www.printables.com/model/784672-slow-slick-rc-plane-mounts-for-dual-8mm-carbon-sha

Printed in ASA with .6 nozzle and .3 layers with 3 walls and 15% infill.