I created this case because all Raspberry PI 1 cases I found did not provide a clean design and left the SDCard accessible directly from outside. I'd prefer to have it integrated into the case preventing acidentially movements.

The tolerance is low, so the case fits quite tight to the Raspberry Pi. I've had to remove a bit of the DAC circuit board beneath the GPIO connector for fitting into the case. The DAC can be fixed with a little screw on the side. There is also an integrated cable routing for the power plug in the base which can be used if the Pi supply connection are originating from one direction. Status LEDs can be viewed through the small slot in carved in the lid.

Support printing is needed for the pocket in the base containing the sdcard.