Foot Button for Sonoff Basic
Dorothystudio
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2026-03-26 00:42:35
0
0
000설명
태그
모델 소스
리뷰(0)
This is a simple button for Sonoff Basic to be able to switch it by foot. It will operate on top of the tiny built-in button. It has a small hole for the built-in button, so you should not be able to break the built-in button even if smashing hard the foot button (theoretically designed, not tested hard, and this may depend on your print, so keep it gentle :-)) The space between the foot button and the sonoff should be enough to allow a smooth slide between the two.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
Yes
Resolution:
0.3
Notes:
To print you should rotate the design to face down the bed. You will certainly need some supports to print. I have chosen to desactivate brim to have clean edges and fillets on the top surface, but as the supports may need some bed adhesion, I have activated the horizontal expansion of supports and brim for supports options in Cura.
태그
모델 소스
원본 링크: 자세히 보기
CC-BY